Issue ASCA Network Configuration Issue

[fueliehead]

I have AS16 and P3D 3.4 set up in a network configuration with P3D on my server PC and AS16 on the client PC. This setup has been working fine.

I recently purchased ASCA. I install it on the client PC and it finds AS16, the install seems fine. When I launch ASCA and go to settings, in the simulator list I see FSX(Boxed). I do not have FSX installed anywhere. I can add my P3D simulator and point the path to the F: drive\folder I have mapped to the server PC where P3D is installed. I can click Make Active, Save and Apply. This seems to work but if I go back to settings the FSX(Boxed) simulator is active. The log has a message that it automatically switched to FSX(Boxed). I do not have FSX so this of course does not work.

If I go back and try to make active the P3D simulator I get the same results and log message and it also creates another simulator entry for FSX(Boxed). I currently have three entries for FSX(Boxed) and the one I created for P3D.

What is the FSX(Boxed) simulator in settings and how can I remove it? I'm guessing for something this odd I probably did something wrong. Any ideas on what I might have done or other suggestions?

Thanks for the help,
hank

 

[Daveo]

Hi Hank,

You can try either deleting the GraphicsOptions.cfg file in the AppData\Roaming\HiFi\AS16CloudArt\ folder or manually edit the paths with a text editor.
If you delete the cfg file you will need to set you options again after starting ASCA.

If you still have problems;

Please submit a support ticket at the Support Desk regarding this issue and reference this forum post also.

Please login to the support desk instead of using email in case you have logs/file attachments over 5MB's in size.

You can login to the support desk here:

http://support.hifitechinc.com/

 

[Driver170]

I have this problem. tried the above but keeps going back to FSX Boxed