Winds aloft stuck at ~150 kt (wind speed limiter value), not matching ASFS conditions

meteoguz

New member
Hi,

In flight, the wind applied in the sim is much stronger than the wind shown in ASFS,
and it seems stuck at the wind speed limiter value.

What happens:
- Flying LTAT to LTFM over Turkey, the aircraft ND showed 309/149 kt at FL360.
- ASFS Conditions at the aircraft position showed a maximum of 120 kt (309/120 at FL390).
- I descended to FL300. ASFS Conditions shows 299/86 kt there, but the ND
still showed about 149 kt. The wind did not change with altitude.
- During the climb, the wind sometimes jumped from about 70 kt to 150 kt within a few
seconds. This caused overspeed, the aircraft pitched up (overspeed protection),
and I got vertical speed penalties.

What I tried:
In flight, I switched the ASFS weather mode away from Live and then back to Live.
After the weather reloaded, the wind was correct for a short time. Then, within
about 30 seconds, it jumped back to about 150 kt.

MSFS Live Weather is OFF. ASFS controls the weather with its preset
("Active Sky FS Weather Preset" is active in the MSFS weather panel).

Settings:
- Enable direct wind control: ON
- Interlayer wind interpolation: ON
- Wind speed limiter: 148
- Maximum wind shear: 100
- Depiction smoothing rate: 38

Setup: ASFS 1.0.9720, MSFS 2024 (Microsoft Store), FlyByWire A32NX, AIRAC 2611.
Screenshots of the ND and the ASFS Conditions screen and my AS_FS_Log are attached.

Thank you!

Screenshot 2026-11-20 001341.png
0031d937-image.png
 
Top